Norton Abrasives C9 Manuel d'utilisateur

OWNERS MANUAL Small Concrete Saw MODEL: C9 FORM <<7418 3/2005

10 2. Remove the blade shaft nut, (Turn clockwise) , and remove the outside collar. 3. Clean off any foreign particles on the clamping surfaces of

11 stability. The water tank adds additional blast (weight) to the machine, which aids in keeping the diamond blade in the cut and reducing vibration

12 13. When moving the saw to a new location, be sure the blade is not touching the ground. Always pay close attention to where you are moving and w

13 III. MAINTENANCE A. Engine Follow the below schedule for engine maintenance. NOTE: Check the Honda Engine manual that came with the engine for an

14 Always refer to the engine manual for more detailed information on checking the oil, changing oil, and oil capacity, air filter changes, and fuel

15 For best results, bearings should be relubricated while in operation. Note: Due caution for personal safety must be observed when servicing rotati

16 7. Line up the straight edge along the outside face of both pulleys as shown in the drawing. 8. Misalignment will show up as a gap between the p

17 IV. PARTS LIST SECTION A. Ordering Information 1. List model number and serial number of machine. 2. List part number and serial number of par

18 C9 Parts Drawing

19 C9 Parts Drawing

2 WARRANTY Norton warrants all products manufactured by it against defects in workmanship or materials for a period of one (1) year from the date of

Service Parts List C9 POS Description Req P/N 1 Blade Shaft (Alone) 1 832802 Nut Blade Shaft ¾'' Lefthand Thread 1 2271563 Bearings

NOTES

Norton Construction Products PO Box 2898 Gainesville, GA 30503 Phone: 800-554-8003 or 770-967-3954 (8:00 A.M. to 7:00 P.M. Eastern Time) Fax: 800-44

3 Table Of Contents CONTENTS PAGE I. Preparation A. Safety Precautions 4-6B. Assembly 7C. C9 Series Concrete Saw Specifications 8D. Engine Specif

4 I. PREPARATION A. Safety Precautions Important! The following safety precautions must always be observed. Hazard Symbols Fuel (gasoline) is extr

5 Dust and Silica Warning Grinding/cutting/drilling of masonry, concrete, metal and other materials can generate dust, mists and fumes containing c

6 1. Before mounting any blade on the saw, the blade should be inspected for any damage which might have occurred during shipment, handling or previo

7 I. PREPARATION B. Assembly The compact concrete saws are shipped completely assembled and ready for use except for diamond blade, gasoline, oil, a

8 C. C9 Series Concrete Saw Specifications Dimensions/Weight Length (Working) 50” (1270 mm) Length (Transport) 40.5” (1029 mm) Width 20.5” (521 m

9 D. Engine Prior to attempting to operate the engine, read the information contained in the engine owner's manual. An engine owners manual is